Ag Leader ParaDyme Radio Option Kits Hardware Installation Guide - Manual (Page 47)

Hardware Installation Guide 41
ParaDyme Smart Antenna Bottom Cover Installation Procedure
ParaDyme Smart Antenna Bottom Cover Installation
Procedure
1. Inspect the ParaDyme Smart Antenna bottom section gasket for defects. If you find it is damaged, pinched, or permanently
deformed, replace the gasket (PN 507-0006-01). Contact your dealer for a replacement. See Figure 4-45.
Note: Figure 4-45 shows only one possible configuration of the ParaDyme Roof Module. Depending on what options
and equipment are installed, your system may appear different than the picture. In all cases, the gasket and groove will
be located in the same location.
2. Inspect the groove around the gasket for cleanliness and defects that could damage the gasket. See Figure 4-45.
Figure 4-45 ParaDyme Receiver Bottom Section Gasket (PN 507-0006-01)
3. Verify that all the coax and ribbon cables and cable clamps are routed and installed as instructed. Coax cables from the
bulkhead adapters to the circuit board must be secured between the two wire clamps. If a ribbon cable is connected to a
UHF or VHF radio, the cable must be folded and routed to pass through recess as described in the installation instructions.
Note: Failure to ensure the coax and ribbon cables are routed properly may cause them to be pinched and or damaged
when the bottom is reattached.
ParaDyme Receiver Bottom
Section Gasket and Grove