Ag-Bag MB7010HyPac - Manual (Page 70)

S
ETUP AND
O
PERATING
P
ROCEDURES
20 Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
The next steps are preformed
using the hydraulic control levers
shown in fig.8. (8a) is for open-
ing and closing the bag pan. (8b)
moves the bag boom extension
in and out. (8c) lowers and raises
the bag boom cable. (8d) rotates
the bag boom in and out. It is
important that you have enough
slack in cable to extend boom.
8. Feed out enough cable us-
ing control (8c) so the hook on
the cable can be attached to the
bag cradle. Raise the cradle
and rotate it using (8d) and (8b)
until you can set the cradle on
the ground near the tunnel
opening, it should be close to
the center of the tunnel. Do not
disconnect cable. Using (8a)
fully open the bag pan.
9. Line the bag box up with the
bag cradle, making sure the ar-
row on the box end is pointing
towards the tunnel. Cut the plas-
tic bands and remove the outer
lid. Remove the inner shell and
plastic inserts and the box will lay
flat. Do not remove tape or rope
until bag is on the tunnel.
10. Unfold the bag and lift the top
half of the bag and place it on the
bag cradle. Using the bag boom
raise the bag and then rotate the
bag on the cradle until (10a) is
located in between the 1 and 3
o’clock (10b)
I
NSTALLING
T
HE
A
G
-B
AG
® B
AG
(
CONT
.)
7
5
6