Flex-a-Lite 485 Black Magic Jeep Wrangler 1987 - 2006 - Manual (Page 2)

C
ONTINUE TO NEXT PAGE TO COMPLETE THE INSTALLATION
.
Yellow butt connector
Crimp the motor wires to the large
supplied wire.
Large red wire
Blue motor wire
Step 7: Wire the fan motors (refer to Wiring Diagram, below)
Using the yellow butt connectors provided, attach a length of the large diameter (10 AWG)
red wire to
the blue motor wire. Attach a length of the large diameter (10 AWG) black wire to the black motor
wire. Once the fan is in place, these will attach to the control module. Tip: Strip an additional 1/8 "
of insulation from the motor wires and fold them over to increase the thickness of the wire
where it will slide into the butt connector.
If mounting the control module to the fan shroud, the
motor wires can be connected now ( see wiring diagram, next page ). If mounting the control some-
where else in the engine compartment, leave enough wire to reach the control module, but do not
connect yet.
Step 8: Wire the control module
Step 8a: Connect the motor wires to the control module
(Red wire to the "M+" terminal and black wire to the "M-" terminal).
Step 8b: Disconnect the negative battery lead for safety while finishing the wiring. Use the large
diameter red (10 GA) wire to run power directly from the battery positive (+) terminal to the "B" termi-
nal on the control module. Connect the fuse holder in-line with this wire, as shown, but do not insert
the fuse yet. Use the yellow female, ring, and butt connectors provided.
rev. 06-27-06 99485 Page 2 of 3