Flex-a-Lite 220 Puller Fan - Manual

Through Core Mounting Instructions
(SEE DIAGRAM “A”)
1.Position the electric fan against the back of the radia-
tor, and mark the holes for mounting.( Some applica-
tions may have A/C condensers and/or transmission
coolers on the front of the radiator. Additional adjust-
ments or modifications may be necessary for installa-
tion
)
2. Rotate fan blades to make sure they are free of ob-
structions.
3. With a small phillips screwdriver pass through the
marked holes, carefully spread the fins to allow easy
passage for the nylon bolts (
4 for the single fan unit, 4
for the double fan unit ). Pass the bolts through the shroud holes
then twist the bolts through the radiator.
4. Slide the rubber washer, then the nylon washer onto the nylon bolt and finger tighten nylon
nuts until snug.
5. Once again, rotate fan blades to insure that they are free of obstruction.
OR
Radiator Support Channel Or Frame Installation
(SEE DIAGRAM “B”)
1. Attach frame mounting brackets to fan using
nylon bolts, cut them to 1",
use nylon nuts to secure.
2. Position fan to desired location, mark holes on
radiator channels or frame.
3. Rotate fan blades to insure that they are free
of obstruction.
4. On the marked hole locations drill 13/64" holes.
5. Secure the fan to radiator using the provided
1/4" x 1" self tapping screws.
6. Check fan rotation.
Nylon
Washer
Diagram A
110&120 210&220
Puller Fans
Installation Instructions
Nylon Bolt
rev. 05-18-05 99876 Page 1 of 3
Model 110 - Single fan w/ thermostatic
control & A/C relay
Model 120 - Single fan w/o thermostatic
control & A/C relay
Model 210 - Dual fan w/ thermostatic
control & A/C relay
Model 220 - Dual fan w/o thermostatic
control & A/C relay
Rubber Disk
Spacer Nylon Nut