Innovate Motorsports XD-16 - Manual (Page 5)

- 5 -
4. Using the XD-16
When the XD-16 powers up it will briefly go through a sequence where it lights up all its LEDs. This is a function
and diagnostic test. Holding down the Control button during power-up will continue to light up all LEDs until the
button is released.
4.1. Sensor Warm-up
For example, this would indicate that he heater is warmed up to 56%. The Function Indicator 2 is lit.
4.2. Heater Calibration
The last digit is the count-down of the heater calibration.
4.3. Free air calibration in process
When shown steady, free air calibration is in progress. If blinking and not going away after 5 seconds, the LM-1
requests a free air calibration as happens after a heater calibration.
Blinking CAL can also happen if the control button is pressed rapidly 3 times. Pressing it then again, initiates a
free air calibration. If this is unintentionally pressed, the CAL request goes away after 5 seconds.
4.4. Normal Operation
With function indicator 1 lit this shows AFR.
4.5. Normal Operation very lean mixture or free air
Switching between and
Shows the free air content of the gas the sensor sees.
4.6. No Connection detected
If the display shows:
The XD-16 cannot receive data from the LM-1 or other devices. Make sure all the connections are fully seated.
4.7. Start/Stop Recording
Press the Control button once to start recording. The Record indicator light will blink.
Press the Control button again once to stop recording. The Record indictor will switch off.
4.8. Clear Recording Memory of LM-1