Innovate Motorsports LMA-3 - Manual (Page 25)

- 25 -
11.4 Input 2 Configuration
Function 1 and 2 of Input 2 use the TK+ and TK- inputs.
The CH2+ and CH2- inputs are used ONLY of this input is set for “external 0..5V sensor”
When selecting one of the side-force modes for Input 2, the center window looks like this:
Select the travel direction of the car. Please note that changing this setting will effect the travel
direction setting for acceleration measurements on Input 5 as well.
11.5 Input 3 configuration
Input 3 has by default duty cycle measurement as function 1. See chapter 10 for details. Duty
Cycle measurement is also available on Inputs 4 and 5.
11.5.1 Measuring Custom RPM
When using the custom RPM feature the center area looks like this:
On the left edit box you can specify the max RPM for this measurement channel. In the example
case the max RPM is 6000. This means that in LogWorks 6000 RPM is equivalent to 5Volt. This
allows LogWorks to have a higher RPM resolution (~ 6 RPM per step instead of 10 RPM when
the range is 0..10230 RPM). This functionality is also available for Inputs 4 and 5.
11.5.2 Measuring Frequency
The center section of the window changes to this: