Innovate Motorsports LM-1 Digital Air/Fuel Ratio (Lambda) Meter - Manual (Page 11)

- 11 -
8. Programming the LM-1
The LM-1 is programmable with the following functionality:
1. Change the relationship between Lambda and AFR.
2. Upgrade and change the firmware.
3. Change the output characteristics of the Analog outputs.
4. Download recorded data into a spreadsheet.
5. Graph and analyze the recorded data.
8.1. Installing the LM Programmer Software
Put the included CD in your CD-drive on your computer and follow the instructions on screen.
The LogWorks Software will be installed including pre-set directories for log-data and
downloaded software.
The following items will be installed on your hard-drive
1. LM Programmer
This is used to program the analog outputs of the LM-1, the fuel type used, the sensor
type used, and also allows to ‘reflash’ the firmware of the LM-1.
2. LogWorks
This is a comprehensive data logging and analysis package to download and analyze
engine data recorded by the LM-1. It also allows real-time logging and display.
3. Manuals for all Innovate Products
4. Tools
5. Example log files
Hooking up the LM-1 device to the computer
- Connect the included serial download cable to a free serial port on your computer.
- With the LM-1 turned off, connect the round Mini-DIN8 connector to the serial port of
the LM-1.
- Start the LM Programmer
- Switch on the LM-1 Instrument.
The LM-1 display shows:
The LM-1 will stay in serial mode until it is switched off, either by its power switch or by
disconnecting 12V if no internal battery is installed.
Your screen should look like this: