Innovate Motorsports LM-1 Digital Air/Fuel Ratio (Lambda) Meter - Manual (Page 12)

- 12 -
On this page you can see the software version of the LM-1, which sensor your LM-1 uses and
you can change the multiplier to calculate AFR from Lambda. A number of different multipliers
are already pre-selectable but you can change it to a custom one for the particular fuel you are
using.
8.2. Resetting the calibration data
Press the Reset Calibration button if you want to reset all calibration data in the LM-1.
This will clear all calibration data of the LM-1.
8.3. Updating the software (LM-1 firmware)
Click the 'Update Firmware' in the main page to upgrade to the latest firmware for the LM-1.
Firmware for the LM-1 has the extension dld. You can download the latest firmware and
software (LM Programmer and LogWorks) from the Innovate! Motorsports web-site at
http://www.tuneyourengine.com
If your computer crashes during a firmware upgrade, the LM-1 has a recovery mechanism where
it will be able to retry the download again and not be disabled by half loaded firmware. Switch the
LM-1 off and on again and then try to restart the LM1 Manager software. The recovery
mechanism is designed to be able to recover 99.9% of the time. While we don’t anticipate this
occurring, it is possible that the LM-1 will not recover correctly and may need to be serviced at
our factory. If you suspect this is the case, contact Innovate support.