Innovate Motorsports OT-1 - Manual (Page 11)

- 11 -
the Driver tab you can click “Update Driver” and install the proper drivers from the included CD.
As with banging your head on the steering wheel, some profanity is permissible should this step
become necessary.
Once Windows reports that the OT-1 is installed and “Working Properly”, you are ready to
proceed to the next step.
3.3 Run LM Programmer
The LM Programmer application can be launched from Start->Programs->LogWorks2->LM
Programmer from the Windows task bar. A small dialog box will appear indicating that the
program is looking for connected Innovate Devices, then the main dialog should appear:
The first tab, shown by default, is a general information page. It will tell you what Innovate device
was found and some basic information about it. You can also use this page to change the OT-1’s
device name or to update the OT-1 with newer firmware (firmware updates can be found and
downloaded from
http://www.innovatemotorsports.com/support.php ).
One piece of information worth noting is the COM port
number assigned to the OT-1 by Windows. It is displayed
on the right hand corner of the page. This is the COM port
number you would use to connect to the OT-1 from a
logging application like LogWorks. This same port
number should be assigned each time the same OT-1 is
attached to the computer (the association is made based
upon the OT-1 unique serial number).
3.4 Select OBD-II Protocol and number of MTS Channels