Innovate Motorsports OT-1 - Manual (Page 19)

- 19 -
This extra resolution comes at the expense of our Low Priority inputs. These channels all share
the ECU ‘bandwidth’ once used by VSS alone. But, this lets us have high resolution critical data
combined with lower priority, lower resolution data in the same log.
3.7 Check and Clear any Vehicle Trouble Codes (Optional)
The last page in LM Programmer displays any Diagnostic Trouble Codes (“DTCs”) currently
reported by your vehicle. Like the Inputs page, the OT-1 must be connected to the ECU for this
page to work correctly.
Standard Trouble Codes are listed both with a number and a description. Manufacturer specific
codes will generally just appear as a number, though sometimes, like the case above, the
general category can be identified.
You can request that the ECU clear the pending codes using the Clear and Refresh button at the
bottom right corner of the page.
Note: On some vehicles, the ignition must be on, but the vehicle not started, for the Clear DTC
request to be accepted.
Now that your OT-1 is installed and configured, you are ready to start logging or displaying it.
See the next Chapter on getting started with LogWorks.