Nitrous Express DRAG-SPORTSMAN N2O - Manual (Page 15)

14
Davis Technologies TM-Drag-Sportsman-MAP V3 2010
current conditions. The settings will not vary much
once you determine what works best for your setup.
Configuring
Trigger Count:
(default= 8)
The unit must be configured for the number of
counts it will receive per revolution of the driveline.
Once set the value will remain until changed by the
user. To change the value, follow these steps.
1. Set the “Setup” dial to “4”
2. Hold down the “Test” button
3. Turn the power On
4. While holding the “Test” button down, move
the dial to the desired number of triggers divided by
two.
(example- 8 triggers/2=4)
5. Release the “Test” button.
The LED will flash to show the number of triggers
the unit is now set to.
(The Trigger Count must be
set correctly for the accurate RPM calculations)
Starting RPM:
(default (15 ) 1500 Rpm)
Once set the value will remain until changed by the
user. The RPM is set in 100 rpm increments,
(example 1500 rpm, divided by 100 = 15). To change
the Starting RPM value, follow these steps.
1. Set the “Setup” dial to “3”