1entering user data, 2controller, 3rpm – Nitrous Express Maximizer 3 User Manual
Page 4: Entering user data, Controller
2
3
3
.
.
1
1
E
E
n
n
t
t
e
e
r
r
i
i
n
n
g
g
U
U
s
s
e
e
r
r
D
D
a
a
t
t
a
a
Drag & Slide – data fields that have this feature have a down arrow button to the right. Clicking and
holding the button causes a slider bar to appear. Moving the mouse left or right while the slider is
displayed will decrease or increase the value.
Increment/Decrement buttons - data fields that have this
feature have up/down arrow buttons to the right. Click on either
of these to increase or decrease the value accordingly.
Menu pull-down – data fields that have this feature have a down arrow button to the right. Clicking
on the button will cause a pull-down menu to appear. To select, click on one of the displayed options.
Typing – clicking on the data field will highlight the value. You can then use the keyboard to enter the
value.
DO NOT connect the controller to your PC until you have installed the software.
3
3
.
.
2
2
C
C
o
o
n
n
t
t
r
r
o
o
l
l
l
l
e
e
r
r
Controller type
sets how the MAXIMIZER-3 will function.
• MAX3 2-stage 40 Amp allows you to control 2 stages
independently. Blue is stage 1 and Red is stage 2.
• MAX3 1-stage 80 Amp is for a 4 solenoid single stage
application. In this mode the controller drives both the blue and
red channels from the stage 1 settings.
• MAX3 Traction Control is the same as MAX3 1-stage 80 Amp but it also turns on the traction
control function. This setting requires the Davis Technologies Traction Control module. For
more information on this function please refer to the traction control module’s manual.
Ramp Reset determines if the controller restarts the ramp and/or delay when it is untriggered. A
check mark means that the controller starts over every time it is triggered. NO check mark means the
controller will continue the ramp from where it left off when it is retriggered. If it is not retriggered
within 20 seconds, it assumes the race is over and resets.
3
3
.
.
3
3
R
R
P
P
M
M
RPM Wire Present turns on the window switch function of the
MAXIMIZER-3. NO check mark removes all RPM related configuration
options and tells the controller to ignore RPM.
RPM Multiplier selects the correct pulse count for the RPM counter. Use the following as a guide to
determine the correct setting:
NX — rev A