5upload / download configuration, Hardware installation, Upload / download configuration – Nitrous Express Maximizer 3 User Manual
Page 8
6
RPM Trigger allows you to set the minimum RPM required before the Nitrous can be triggered.
Start sets the start percentage of the stage at 50% throttle.
Final sets the final percentage of the stage at 100% throttle.
Solenoid Frequency sets the rate at which the controller will pulse the solenoids. 14 hz works with
most solenoids.
3
3
.
.
5
5
U
U
p
p
l
l
o
o
a
a
d
d
/
/
D
D
o
o
w
w
n
n
l
l
o
o
a
a
d
d
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
DO NOT connect the controller to your PC until you have installed the software.
Before programming the MAXIMIZER-3, it must first be installed in your vehicle because it requires
12-volt power. To connect the MAXIMIZER-3 to your PC, use the USB cable supplied with the kit.
Plug the USB cable into an available port on your PC.
Once the software has identified the MAXIMIZER-
3, the buttons will become fully visible and the
connected ICON will be green.
Clicking on the UPLOAD button will store your settings in the
controller. The “Config Uploaded” window will appear following a
successful upload.
Clicking on the DOWNLOAD button will read your settings from the
controller. The “Config Downloaded” window will appear following a
successful upload.
The PC program will remember the current MAXIMIZER-3 settings when you close it.
4
4
.
.
H
H
a
a
r
r
d
d
w
w
a
a
r
r
e
e
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
The MAXIMIZER-3 is designed to be installed almost anywhere on the vehicle. Select a location that
is away from heat sources that can damage the wires. Before permanently installing the device, we
recommend that you complete the installation procedure below, as you will need access the push
button and have a clear view of the LEDs for the final steps. Using the wiring diagram applicable to
your application, connect the harness as illustrated.
Power Input (white) should be connected to the arming switch and fused for 5 amps
Controller Ground (black 18awg) should be connected to chassis ground as close as possible to
the battery.
Never disconnect this wire while the controller is connected because you will
damage the electronics.
Solenoid Ground (black 12 awg) should be connected to a separate chassis ground and not the
same one as used for the controller ground.
NX — rev A