Nitrous Express Octane Series Bottle Volume User Manual
Page 11
SCROLL DOWN:
This is your HI bottle pressure set point. If your bottle pressure rises above this point your
cutoff relay will be activated. Push the control button in (text will change to blue) and make
adjustments up or down to fit your needs. Once your hi side pressure is set, push the control
button in to save it.
SCROLL DOWN:
This is the delay for the nitrous pressure. This determines how long the bottle pressure must
be above you hi set point or below your low set point before activating the cutoff relay. Push
the control button in to adjust this up or down. Once your delay is set, push the control button
in again to save it.
SCROLL DOWN:
This will allow you to set the same settings for sensor #2 as you did for the nitrous bottle pressure. Once you have
finished setting your cutoff selections, scroll to the Exit and push the control button in to return to the Exit and Save
screen.
Pushing the control button in at this time will save and return you to the Main Viewing Screen.
C
C
a
a
l
l
i
i
b
b
r
r
a
a
t
t
i
i
n
n
g
g
B
B
o
o
t
t
t
t
l
l
e
e
C
C
a
a
p
p
a
a
c
c
i
i
t
t
y
y
Note: Before calibrating the gauge you must have correctly configured the gauge and have a
full tank connected to your system
Press the control button and scroll to Reset Full Bottle. Press the control button in and the gauge
will now be set to full and will return to the main screen. Now use you nitrous system as you would
normally.
Note: Because EMPTY is subjective, different users will have different levels at which they consider
the bottle to be empty. The gauge is programmed with a default empty level and may not accurately
display the true level in your tank until you have calibrated it. If the tank shows empty but it is not, continue to use the
system as you would have before.