Nitrous Express Octane Series Bottle Volume User Manual
Page 8
This is the Red to Yellow change which is a visual aid for the main viewing screen. The nitrous
pressure display on the Main Viewing screen will change from red to yellow at this point. Push
your control button in (the text will change to blue). Make adjustments up or down to fit your
needs. If you hold the control button in the up or down position the numbers will scroll. Once you
have the number programmed for your needs, push the control button in to save it.
SCROLL DOWN:
This is your low-side scaling and sets the lower limit of the Main Viewing screen. The closer this
number is to your actual low-side the more accurate your scaling resolution is. Normally 150-200
psi lower then Red to Yellow transition is a good place to be. Push the control button in (text will
turn blue) and make adjustments up or down to fit your needs. Once done, push the control
button in to save it.
Scroll to the Exit and push the Control button in.
S
S
T
T
E
E
P
P
6
6
.
.
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
e
e
s
s
e
e
t
t
u
u
p
p
-
-
-
-
S
S
e
e
n
n
s
s
o
o
r
r
#
#
2
2
.
.
Push your control button in.
This is your Sensor #2 setup screen. The #2 sensor can be air/fuel, AFR, Nitrous, Coolant,
MAP, Water, Oil, Fuel, and Other. This is also what your Safety Cut-outs will use for its labelling
and the labelling on the Main Viewing Screen.
SCROLL DOWN:
Push the control button in (the text will turn blue) and adjust up or down to find the sensor that fits
your needs. Your choices are, None, 15psig, 50psig, 100psig, 200psig, 1500psig, 1600psig,
Air/Fuel. For Air/Fuel you attach the analog output wire from your wideband. The analog signal
of the wideband must be a linear 5v ramp where 0.5v =10 AFR and 4.5v=20AFR.
Once you have selected the sensor for your needs, push the control button in.
SCROLL DOWN:
Push the control button in (the text will turn blue) and adjust up or down to find the Label for the
sensor you have chosen. Your choices are AFR, Air/Fuel, Other, Fuel, Oil, Air, MAP, Water,
Coolant, Nitrous. This is the label you will see on the Main Viewing Screen for your #2 Sensor.
Once you have selected the label, push the control button in to save it.