Nitrous Express Octane Series Bottle Volume User Manual
Page 5
S
S
T
T
E
E
P
P
3
3
.
.
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
e
e
s
s
e
e
t
t
u
u
p
p
-
-
-
-
S
S
t
t
a
a
g
g
e
e
S
S
e
e
t
t
u
u
p
p
s
s
.
.
This is where you will set up the Horsepower levels of your stages and tell the controller how the
solenoids are turned on/off.
SCROLL DOWN:
This is your Stage 1 Horsepower level. Push the control button (numbers will change to blue)
and adjust up or down until it matches your HP jetting. Use the HP rating your nitrous company
publishes. Once you have your HP level programmed, push the control button in.
SCROLL DOWN:
This is your Stage 1 Polarity. Your choices are +++ (positive) or
- - -
(negative). You can
connect your Stage sensing wires to the Positive or Negative side of your nitrous solenoids.
Pushing the control button in will toggle between these two settings.
Note: +++ is used for systems where the power is switched on/off to fire the solenoids.
- - -
is
used when the negative side is switched to fire the solenoids.
- - -
is used by most progressive
controllers.
SCROLL DOWN:
This is your Stage 2 Horsepower level. Push the control button (numbers will change to blue) and
adjust up or down until it matches your HP jetting. Use the HP rating your nitrous company
publishes. Once you have your HP level programmed, push the control button in. If no 2
nd
stage
is being used in your application you can attach this wire to your purge valve. Most purge valves
are similar to a 150hp level.
SCROLL DOWN:
This is your Stage 2 Polarity. Your choices are +++ (positive) or
- - -
(negative). Your can
connect your Stage sensing wires to the Positive or Negative side of your nitrous solenoids.
Pushing the control button in will toggle between these two settings.
Note: +++ is used for systems where the power is switched on/off to fire the solenoids.
- - -
is
used when the negative side is switched to fire the solenoids.
- - -
is used by most progressive
controllers.
Once you have programmed the POL setting, then Scroll Down to the EXIT and push the control button in. This will return
you to Exit & Save Screen. You are now on Bottle Level. Push your control button in to enter this set up.