Installation of wind sensor – Vaisala WS425FG User Manual
Page 28
User's Guide ______________________________________________________________________
26 ______________________________________________________________________________
Installation of Wind Sensor
1.
Open the sensor shipping box and remove the sensor.
2.
Take the wind sensor and connect the cable connector to it. Then
insert the sensor over the end of the adapter. The sensor needs to be
rotated until its alignment pin slides into the slot of the adapter.
Tighten the single set screw that secures the sensor to the adapter.
Installation of Power Supply
Installation of Power Supply on Pole
Mast
1.
Take the mounting plate out of the mounting kit assembly
container.
2.
Take the power supply out of its shipping container.
3.
Attach the power supply to the mounting plate with four flathead
screws and four each flat washers, lock washers and ¼-20 nuts
found in the mounting kit assembly container.
4.
After these four screws are tightened, mount the entire assembly on
the pole mast, using the four hex-head screws as shown in
Figure
10 on page 27
. The customer must provide the pole mast and the
pole mast installation plate.
CAUTION
After removing the sensor from the box, do not impact the three
transducers against hard objects or damage to the sensor might result.