Vaisala WS425FG - Manual (Page 50)

User's Guide ______________________________________________________________________
48 ______________________________________________________________________________
Example of the WF Command Message
The following is an example of the output from the sensor for the WF
command:
WFF6785672109876.5432.1K99xx
WR Command
This is the system reset command. The command format is:
WR CR LF
Peak wind direction = 567
Wind averaging time = 21
Peak wind averaging time = 09
Wind speed = 876.5
Peak wind speed = 432.1
Table 5 Explanation of the WF Command Message
Byte Description Value
1 Start to text STX
2 Sensor ID W
3 Command identifier F
4 Sensor status F
5-7 Fixed wind direction 678
8-10 Fixed peak wind direction 567
11-12 Averaging time for wind speed and direction 21
13-14 Averaging time for peak wind speed and
direction 09
15-19 Fixed wind speed 876.5
20-24 Fixed peak wind speed 432.1
25 Wind speed units K
26-27 Signal quality 99
28-29 Hex checksum xx
30 End of text ETX
31 Carriage return CR
32 Line feed LF