ARI Armaturen ARImetec-S EN - Manual (Page 18)

Page 2-18 Rev. 0040807015 1014
Operating Instructions
ARImetec
®
-S
To delete the current data set, you must press button "F2" on the information screen. You
then see a confirmation prompt asking whether you are sure you want to delete this data:
Press button "F3" to confirm the prompt or "F1" to cancel the deletion.
6.7.2.5 Starting / overwriting the selected long-time test
The final option in the "Long-time test" menu allows you to start a long-time test that has
already been parameterised or overwrite an existing test. To do this, you press button "F3".
6.7.3 Single test
When you select the "Single test" function, you see an overview of all single tests created
so far, together with their respective test points and statuses: The test values to be stored
are saved in the single test selected as "Active".
You can create a new single test by
pressing button "F2", change the current
test by pressing the control knob or activate
the selected single test with "F3".
By activating a single test, you cause all
test values stored in check mode to be
stored in this test.
The "Active" status can only be selected for
one single test at a time. You cannot
activate several single tests
simultaneously.