ARI Armaturen ARImetec-S EN - Manual (Page 32)

Page 2-32 Rev. 0040807015 1014
Operating Instructions
ARImetec
®
-S
8.0 Care and maintenance
8.1 Testing device
Never use cleaners containing solvents.
The device and all accessories can be cleaned with a damp cloth. Aggressive detergents
may attack the plastic housing and impair the mechanical stability of the ARImetec
®
-S .
The ARImetec
®
-S must be protected against moisture, in order to prevent damage.
9.0 Troubleshooting
Not every fault necessarily means a defect in the device. You can save time and money by
checking for and correcting a few simple faults yourself.
If you cannot correct the fault with the help of the table in section "10.0 Troubleshooting
table", please consult the supplier or manufacturer.
10.0 Troubleshooting table
11.0 Disposal
ARImetec
®
-S testing devices are B2B products that are only intended for use in
commercial or industrial applications to assess valves and steam traps. Public waste
disposal authorities are not responsible for disposing of them. The devices contain batteries
that are not allowed to be disposed of as domestic refuse!
Old devices can be returned to the manufacturer.
The cost of shipping the equipment must be borne by the customer.
Fault Possible cause Corrective measure
Device cannot be switched on Batteries are discharged Recharge batteries
No acoustic signal detected Volume too low Increase volume
Sensor not securely connected Connect plug securely
Headphones not securely
connected Connect headphones securely
Device switched off automatically Switch device on again
Sensor defective Test with another sensor
Red charge LED blinks Internal batteries or charging circuit
defective
Send in ARImetec
®
-S for
inspection