ARI Armaturen ARImetec-S EN - Manual (Page 9)

Rev. 0040807015 1014 Page 2-9
Operating Instructions
ARImetec
®
-S
6.0 Start-up / operation
6.1 Inserting the batteries
ATTENTION !
- LR batteries with 1.5 V rated voltage are required to operate the ARImetec
®
-S .
- There must be no USB connection to a PC when you open the lid of the battery
compartment.
- Note the polarity engraved on the battery block when you insert the batteries.
- Follow the instructions described below!
a) Detach the shoulder strap from the lid of the
battery compartment.
b) Unscrew the locking screw of the battery
compartment as far as it will go. The battery
block moves in the same direction as the
screw. It is important to keep a tight grip on
both the battery and the device.
c) Open the battery compartment downwards
and pull it out of the device back.
d) Remove the batteries from the battery block.
e) Insert new batteries in the block, taking care
to fit them the right way round (polarity).
f) The correct battery position is engraved on
the top of the block.