ARI Armaturen ARImetec-S EN User Manual
Page 19
Rev. 0040807015 1014
Page 2-19
Operating Instructions
ARImetec
®
-S
You create a new single test or change an existing test in the menu below:
You store the test values and measurement data in check mode by pressing the control
knob.
The following information is stored for each test:
- Date / time
- Sensor type
- Check mode / mixer frequency
- Ultrasonic level
- Temperature value
You can only archive single tests using "SONAPHONE Communicator", the PC software
available as an accessory.
You select the character you want to
change by pressing the control knob and
set it by turning the knob. By pressing
button "F1", you go back to the character
that was changed previously.
To change the character set (ABC --> abc
--> 012 --> :;<), you press button "F2".
By pressing button "F3", you store both the
name of the tester and the test point for the
selected single test.