Videoswitch Vi605 - Manual (Page 42)

Digital Recorder
38
Enable PIRs
Specify which wireless PIRs are installed.
[<][>] Move cursor to select PIR
[^][v] Select whether PIR is installed
Weekday Times
Specify during which hours of the week the wireless PIR detection is active
[<][>] Move cursor to select hour of day
[^][v] Select whether PIR is active
Weekend Times
Specify during which hours of the weekend the wireless PIR detection is active
[<][>] Move cursor to select hour of day
[^][v] Select whether PIR is active
Camera Mapping
Each of the 64 wireless PIRs may be mapped to a camera. It will be this camera that is
pulled-up in full screen.
Preset Mapping
Each of the 64 wireless PIRS may be mapped to a preset number. If the PIR is triggered,
this preset will be called up on the camera to which the PIR is also mapped. This only
applies do domes which have telemetry control.
Critical Alerts
Critical alerts are conditions that require user intervention.
If a critical alert condition arises, it is recorded in the event log.
A message is also displayed on the main monitor to alert the user attention is required.
Critical alerts are reset by pressing [OK] while viewing the event log.
Critical alerts arise if a hard drive fails, if a system self-test fails, or if video is lost from a
user defined list of which input should have video.
Video Loss
Specify here which cameras should be present. If any lose video, a critical alert will be
raised.
[<][>] Move cursor to select a camera input
[^][v] Select whether camera should be present
[TAG] Default to all currently connected cameras
Erase Event List
The event list can be erased here. Use with care as the events cannot be retrieved once
erased.
Press [OK] to erase all events.