Videoswitch Vi605 - Manual (Page 45)

Digital Recorder
41
[OK] Go to preset
Set Preset
[^][v] Select preset
[OK] Set preset to current position
Tour Programming
Dome tours may be set here. Note that with some times of dome, the tours have to be set
via the dome menu. Use the FN key to start and stop tours.
If an alarm accours, tours will be suspended but can be re-instated after the alarm has
finished. Refer to Alarm section.
Start Programming Tour
[^][v] Select a tour
[OK] Start programming tour
Add Preset to Tour
[^][v] Select a preset
[OK] Add preset to tour
Finish Programming Tour
[OK] Finish programming tour
DVR Driven Tours
As well as programming tours into the domes, the DVR can sequentially invoke presets to
create a tour. This is done independently for each dome camera. Use the FN key to start
and stop DVR driven tours.
No of Presets in Tour
Program the presets 1, 2, 3 etc into a dome that you wish to use for the tour. Use this menu
setting to specify how many are to be sequenced.
Dwell Time
Specify here for how many seconds you wish to dwell on each preset before moving on to
the next one.
9.6 Network
Images from this DVR can be remotely viewed and menus accessed via:
Telephone line - connect Vi PSTN module to the modem port.
Local area network - connect to the Ethernet port.
Broadband - connect a router to the Ethernet port.
IP Address
If you wish to use the Ethernet port for local or Ethernet access, you need to give the DVR
an IP address.