Kenwood DNX4230TR User Manual
Page 6
10
10
11
DNX4230DAB/DNX4230BT
4 3
1
2
5
6
9
7
8
NOTE
• The panels shown in this guide are examples used to provide clear explanations of the operations. For this reason,
they may be different from the actual panels.
• In this manual, each model name is abbreviated as follows.
DNX4230DAB and DNX4230BT :
If above icons are showed, read the article applicable to the unit you use.
How to insert a microSD Card
1) Open the
9
microSD card slot cover
as the illustration in the right.
2) Hold the microSD card with the label
facing up and the notched section right,
and insert it into the slot until it clicks.
●
To eject the card:
Push the card until it clicks and then remove your
finger from the card.
The card pops up so that you can pull it out with
your fingers.
Number
Name
Motion
1
Disc insert
slot
A slot to insert a disc media.
2
0 (Eject)
• Ejects the disc.
• Pressing for 1 second ejects the disc forcibly.
3
fi (Reset)
• If the unit or the connected unit fails to operate properly, the unit
returns to factory settings when this button is pressed
.
• If the Security Indicator (SI) function is turned on, this indicator flashes
when the vehicle ignition is off
.
4
Remote
Sensor
Receives the remote control signal.
5
MENU
• Displays the Top Menu screen
• Pressing for 1 second turns the power off.
• When the power off, turns the power on.
6
NAV
• Displays the navigation screen.
• Pressing for 1 second switches AV out sources.
7
Volume Knob • Turning adjusts volume up or down.
• Pressing switches attenuation of the volume on/off.
• Pressing for 1 second displays the Tone Control screen
.*
8
TEL
• Displays the Hands Free screen
• Pressing for 1 second displays the Voice Recognition screen.
9
microSD
card slot
A microSD card slot for upgrading the map. For how to upgrade the map,
refer to the instruction manual of the navigation system.
* The display may not switch to the Tone Control screen in some conditions.