Kenwood DNX4230TR - Manual (Page 9)

16 16 17
Return to the Top page
Basic Operations
Return to the Top page
Basic Operations
SD card
DNX7230DAB: Press the <0>
button for 1 second to open the
front panel.
0
The panel fully opens.
DNX5230DAB/ DNX5230BT:
Detach the front panel.
NOTE
• For how to detach the panel, see How to insert a
microSD Card (P.8) .
Insert the card into the slot until
it clicks.
The unit loads the card and playback
starts.
● To remove:
Push the SD card until it clicks and then
remove your finger from the card. The
card pops up so that you can pull it out
with your fingers.
External device
Insert the plug into the AV-IN jack.
1
2
1
D
etaching The Front
Panel
You can detach the front panel to prevent
theft.
Press the < 0> button for
1 second to open the front panel.
0
NOTE
• You can set the front panel to open automatically
when the ignition is turned off. See Monitor
angle control (P.82) .
Detach the panel as the diagrams
below.
2
3
1
4
NOTE
• The attaching plate closes automatically in about
10 seconds after the front panel is released.
Remove the panel before this happens.
Slide the Release key upward to
detach the part of the front panel.
Then, detach the panel as the
diagrams below.
1
2
● After detaching:
Put the panel in the protective bag
supplied with the unit.
NOTE
• When detaching a part of the front panel, detach
it toward the front side as shown in the diagram
above. If it is detached upward, the front panel
will be broken.
• To prevent deterioration, do not touch the
terminals of the unit and faceplate with your
fingers.
• If the terminals on the unit or faceplate get dirty,
wipe them with a clean soft dry cloth.
1
2
1
Continued