Kenwood TS-590S - Manual (Page 13)

13
4.3. Transceiver Settings
Make the settings required to implement KNS operations using transceivers.
● Set the audio path settings
With KNS operations, normally transmitted audio is input from an ACC2 connector.
Input is also possible using USB audio functions from a USB connector, but as the
delays are great, this is not recommended.
Make the following menu settings to transmit audio input from the ACC2 connector.
Menu No. Function Set value
63 Audio input line selection for data
communications ACC2
The default setting is ACC2.
Reference:
Set the menu described above to USB to transmit USB audio signals input to the
USB connector.
Set the (existing) device connected to the TS-590S to the playback and recording
devices using the PC sound settings on the host station.
● Data VOX settings
With the TS-590S, VOX functions can be implemented using either audio input to the
ACC2 connector or USB audio signals input to the USB connector, but to prevent
unintentional transmission during KNS operations, turn OFF the function using the
menu settings.
Menu No. Function Set value
69 Data VOX OFF
The default setting is OFF.
Caution:
¾
There is a risk that sounds other than those produced by the computer may be
transmitted unintentionally over the network, so we recommend that you turn off
this function.
¾ When this function is ON, all sounds created by the computer other than the
intended audio transmissions are also transmitted, so be careful.
¾ When using this function for the first time, we recommend connecting a dummy
load to the TS-590S to perform checks and adjustments.