Kenwood TS-590S - Manual (Page 14)

14
● Audio I/O level settings
Use the following menu to adjust audio transmission input levels from the PC, and
receive audio output levels to the PC.
Menu No. Function Setting range
64 Audio level of USB input for data
communications 0～9
65 Audio level of USB output for data
communications 0～9
66 Audio level of ACC2 input for data
communications 0～9
67 Audio level of ACC2 output for data
communications 0～9
The default value for all settings is 4.
Reference:
Adjust the PC sound function volume as necessary.
● Mixed beep setting to external audio outputs
With the TS-590S default mode, only received audio signals that do not include beeps
or side tones are output as audio signals from the ACC2 connector and the USB
connector as USB audio signals.
Make the following menu settings to output the same audio as the audio output from the
wireless speaker, including beeps and side tones, externally.
Menu No. Function Set value
68 Mixing beep tones for ACC2/USB audio
output ON
The default setting is OFF.
Reference:
To implement data communications, turn this function OFF.
● Timeout timer settings
During KNS operations, control data signals are transmitted using the network.
Consequently, if normal network operations are disabled for any reason, control of the
transceiver will also be disabled. Use the following menu to set the functions to stop
transmitting automatically after a fixed period if control should be disabled while
transmitting.
Menu No. Function Set value
49 Time-out timer except OFF
(See Note)
The default setting is OFF.