Videotec ULISSE MAXI - Manual (Page 20)

EN - English - I
nstruc
tions manual
18
7.2.2 Fixing the base to the support
h To fasten the support use the specific bolts
and screws supplied with the base.
After having positioned gasket (01), fasten base (02)
on support (03) using screws (04), toothed spring
washers (05) and the rings for screw (06).
03
02
04
05
06
01
Fig. 28
03
02
04
05
06
01
Fig. 29
Align the 3 notches on the base with those on the
support as shown in the following figure.
Fig. 30
h Apply a Loctite 243® type thread-locker on
the holes of the screws.
h Fasten with tightening
torque of 4Nm.
Insert the cables into the cable glands and, holding
the base at about 20cm from the support, lock
the cable glands with a torque wrench setting of
5Nm. The cable glands are suitable for cables with
diameters of between 5 and 10mm.
Fig. 26
j For smaller cables (from 3 to 7mm) use the
supplied gaskets.
Fig. 27