Videotec ULISSE MAXI - Manual (Page 44)

EN - English - I
nstruc
tions manual
42
For telemetry, leave the default settings.
Fig. 102
After all the settings have been inserted, remember
to Save & Reboot, so that the changes will take
effect.
• Factory Default: Used to restore default factory
settings.
h In extreme cases, when you have forgotten
the password for accessing the unit via the
browser, you can also restore the factory
settings by pressing a Reset button situated
inside the base.
RESET button
Fig. 103
For Reset to take effect, you have to disconnect the
power supply to the pan & tilt and then press the
reset button, and keep it pressed while reconnecting
the power supply.
Keep the button pressed for 5 seconds.and then
release it.
The factory default values of the unit are restored.
9.7.2.1 WAN setting
Next, set the static IP address, which is used to
gain access to the unit that is to be configured. For
example, set a static IP and address 192.168.0.101.
Fig. 101
Next, click on Apply and then click on Save &
Reboot. Wait about 30 seconds, until the settings
have been saved. Re-connect to the modified address
(e.g. 192.168.0.101), inserting the Account Name and
Password (use the default settings if they have not
been changed).
Then edit the other parameters, for example:
• Date Setting: To set date and time.
• Video Setting: To change resolution (720x576,
640x480, 352x288, 176x144) bit rate (setting
between 28kbit and 3 Mbit).