Videotec ULISSE MAXI - Manual (Page 25)

EN - English - I
nstruc
tions manual
23
7.3.2 Counterweights adjustment
h For the correct operation of the pan & tilt
function, the counterweights have to be
adjusted.
Loosen the weight’s locking screws (01).
Move the weights to the desired position.This
must be the same for both weights, to help with
this, use the reference holes (02) at the back of the
counterweights.
01
02
Fig. 45
For the pan & tilt’s correct operaration the casing
must remain balanced, possibly in the horizontal
position (for this, check by lightly swinging the
housing).
Fig. 46
Tighten the screws.
7.3.1 Counterweights installation
h Fully fasten the counterweights to the
casing by means of the M5 screws and
washers supplied as standard.
h Apply a Loctite 243® type thread-locker on
the holes of the screws.
h Fasten with tightening
torque of 4Nm.
Fig. 43
Fasten the 4 safety grub screws of the
counterweights’ pins.
Fig. 44
h For correct operation and for safety
reasons, we recommend that you carefully
check the proper tightening of screws
and grub screws for the fastening of
counterweights.