Videotec ULISSE MAXI - Manual (Page 30)

EN - English - I
nstruc
tions manual
28
9 Configuration
9.1 On Screen Menu (OSM)
During normal ULISSE operation it is possible to
activate the On Screen Menu in order to set the
advanced functions using the corresponding key/s
(see the handbook for the keyboard you are using).
Exit the On Screen Menu with Zoom Wide (or
Zoom-).
9.1.1 How to use the joystick
All operations in the menus are carried out using the
joystick.
Up
Down
Left Right
Fig. 57 Pan & tilt.
Exit Confirm
Fig. 58 Zoom wide & tele.
j If using a control keyboard with a dual axis
joystick, use the Zoom Wide and Zoom
Tele keys to carry out the Exit and Confirm
commands.
8.1 Before powering the device
The first time the device is switched on we
recommend making sure it is configured correctly.
To do this, disconnect the power supply, remove the
dip-switch protection window and set the firmware
update dip-switch rocker to ON.
Power the device and after a few seconds it will be
possible to check the settings on the screen.
After completing the check, switch off the device
and re-toggle the firmware update dip-switch rocker
to the down position (number 1 in the baud rate
section).
Close the window and re-connect the power supply.
8.2 Checks list
While it is switching on, the device displays a list of
the checks it has to carry out before starting normal
operation.
STARTUP
------------------------
TEST FLASH : OK
HOMING PROCEDURE : OK
ZFI SEARCH : OK
IO EXPANDER :OFF
IR360 STATE :OFF
Fig. 56
h If one of the checks fails (ERR), seek
assistance. The message Off means that the
pan & tilt is not fitted with the described
option.