MagTek Bluetooth MagneSafe V5 Swipe Reader - Manual (Page 31)

Section 5. Communications
23
GET AND SET PROPERTY COMMANDS
The Get Property command gets a property from the reader. The Get Property command
number is 00.
The Set Property command sets a property in the reader. The Set Property command number
is 01. For security purposes, this command is privileged. This command must be MACed in
order to be accepted.
The Get and Set Property command data fields for the requests and responses are structured as
follows:
Get Property Request Data:
Data Offset Value
0 Property ID
Get Property Response Data:
Data Offset Value
0 – n Property Value
Set Property Request Data:
Data Offset Value
0 Property ID
1 – n Property Value
Set Property Response Data:
None
The result codes for the Get and Set Property commands can be any of the codes listed in the
generic result code table. If the Set Property command gets a result code of 0x07, it means the
required MAC was absent or incorrect.
Property ID
Property ID is a one-byte field that contains a value that identifies the property. The following
table lists all the current property ID values:
Value
(Hex)
Property Description
00 SOFTWARE ID The reader’s software identifier
03 DEVICE SERIAL NUM Reader serial number
04 Reserved for future use
05 TRACK ID ENABLE Track enable / ID enable
06 Reserved for future use
07 ISO Track Mask Specifies Masking factors for ISO cards
08 AAMVA Track Mask Specifies Masking factors for AAMVA cards
09-0A Reserved for future use
0B Activity Timeout Period
Specifies minimum time reader will operate in the
absence of activity (used to conserve battery life)
0B-0C Reserved for future use
0D Bluetooth Disconnect Message Message to be transmitted when reader disconnects
0E Stay Powered After Swipe Allows reader to stay powered after a good swipe
0F Reserved for future use
10 Interface Type Type of interface