MagTek Bluetooth MagneSafe V5 Swipe Reader - Manual (Page 32)

Bluetooth MagneSafe V5 Swipe Reader
24
Value
(Hex)
Property Description
11-13 Reserved for future use
14 Track Data Send Flags Track data send flags
15 MP Flags Enables sending of MagnePrint data
16-18 Reserved for future use
19 CRC FLAG Enables/disables sending CRC
1A SureSwipe Flag Sends data in SureSwipe format without MagnePrint
1B-1D Reserved for future use
1E Pre Card String Pre card string
1F Post Card String Post card string
20 Pre TK String Pre track string
21 Post TK String Post track string
22 Termination String Terminating string
23 FS Field Separator for additional data
24 SS TK1 ISO ABA Start sentinel char for track 1 – ISO/ABA
25 SS TK2 ISO ABA Start sentinel char for track 2 – ISO/ABA
26 SS TK3 ISO ABA Start sentinel char for track 3 – ISO/ABA
27 SS TK3 AAMVA Start sentinel char for track 3 - AAMVA
28 SS TK2 7BITS Start sentinel char for track 2 – 7 bit data
29 SS TK3 7BITS Start sentinel char for track 3 – 7 bit data
2A Reserved for future use
2B ES End sentinel char for all tracks/formats
2C Format Code Defines the Format Code to be sent with the message
2D ES Track 1 End sentinel char for track 1
2E ES Track 2 End sentinel char for track 2
2F ES Track 3 End sentinel char for track 3
30 Send Encryption Counter Enables/disables sending of Encryption Counter
31 Mask “Other” Cards
Enables/disables masking of don’t meet the ISO
Financial format or the AAMVA format.
34
Send clear AAMVA card data
flag
Enables/disables sending AAMVA data in the clear.
The Property Value is a multiple-byte field that contains the value of the property. The number
of bytes in this field depends on the type of property and the length of the property. The
following table lists all of the property types and describes them.
Property Type Description
Byte
This is a one-byte value. The valid values depend on the property.
String This is a multiple byte ASCII string. Its length can range from zero
to a maximum length that depends on the property. The value and
length of the string does not include a terminating NUL character.
Property Default Values
Each property specifies a default value. This is the firmware default value and may be changed
during the manufacturing or order fulfillment process to support the needs of specific clients.
SOFTWARE ID PROPERTY
Property ID: 0x00
Property Type: String
Length: Fixed at 11 bytes
Get Property: Yes
Set Property: No