MagTek Bluetooth MagneSafe V5 Swipe Reader - Manual (Page 36)

Bluetooth MagneSafe V5 Swipe Reader
28
ACTIVITY TIMEOUT PERIOD PROPERTY
Property ID: 0x0B
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 120 (0x78) seconds
Description: This property specifies, in seconds, the minimum amount of time a Bluetooth
reader will operate in the absence of activity. Activity is:
• Swiping and processing of a card.
• Receipt and processing of commands from a Host.
• Briefly pressing the User Switch
When the specified time passes without activity, the reader is powered down.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled for these changes to take effect.
BLUETOOTH DISCONNECT MESSAGE PROPERTY
Property ID: 0x0D
Property Type: String
Length: 7 bytes
Get Property: Yes
Set Property: Yes
Default Value: The default value is no string with a length of zero.
Description: This property specifies a string to be used as part of a Bluetooth Disconnect
Message. The message is intended to give the connected host application a
warning that the reader is disconnecting. The full disconnect message consists
of the specified string followed by the character ‘-‘ (hyphen), followed by a
single character Reason Code, followed by a Carriage Return (0x0D)
character. The possible Reason Codes are:
‘T’ = Timeout
‘U’ = User Switch
‘B’ = Battery Low
‘S’ = Card Swipe
‘R’ = Reset command
‘I’ = Interface changed
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled for these changes to take effect.