Installing the cover, Installing telephones – Avaya PARTNER-18D User Manual

Page 27

Advertising
background image

2 Installing Your System

Installing the Cover

17

Quick Reference Guide

10

Gather the line and extension cords hanging below the wire managers of
the first two modules, and twist-tie or wire-wrap them. Repeat for the
remaining cords. For the 5-slot carrier, place each bundle of wires in the
indentations cut out of the bottom edge of the carrier.

Installing the Cover

If you have a 5-slot carrier in a system of Release 3.0 or earlier, it is important to
install the cover to keep the modules dust-free and properly seated, and the
system working efficiently. Install the cover for the 5-slot carrier by following
these steps:

1

To cover the modules, grasp the upper edges of the cover and hold it
squarely over the control unit.

2

Place the cover over the modules and make sure it fits firmly in place.

3

Insert the #6 screw into the tab on the lower front of the cover. Tighten the
screw.

Installing Telephones

After you have installed the control unit and have connected the line and
extension cords, you are ready to install the telephones. Installing the telephones
includes assembling, connecting, and testing the telephones. As desired, you
also can connect an Intercom Autodialer to system telephones at operator
extensions. See the PARTNER

Advanced Communications System Installation,

Programming, and Use guide and the documentation that comes with the
telephone.

Advertising
This manual is related to the following products: