Avaya PARTNER-18D - Manual (Page 21)

2 Installing Your System
Installing the Control Unit 11
Quick Reference Guide
CAUTION:
Do not force the module. Use the carrier shelf as a reference and do
not tilt, slant, or rotate the module. If the module does not insert easily,
remove it, clear any obstruction, and reinsert it.
Labeling Jacks
After you have mounted the control unit on the wall, you must label the line and
extension jacks. The line jacks are on the top of the modules, and the extension
jacks on the bottom.
Follow these steps to label the line and extension jacks:
1 Label the line jacks on the processor module, beginning with “1” at the top
line jack.
2 Do one of the following:
• For a 2-slot carrier, label the line jacks on the other module.
• If you use a 1600 DSL module, it must be in the first slot on the
left. The 012E, 308EC, and 206 modules must be to the left of
any 400 and 200 modules.
• PARTNER ACS Release 5.0 or later supports Endeavor
telephones when an Endeavor 362EC module is installed in the
carrier. Install the Endeavor 362EC module(s) to the right of the
1600 DSL module, if one is installed, and to the left of all 400
and 200 modules.
• In Release 5.0, the system extension maximum is 48. However,
in some configurations, the 012E module and/or the PARTNER
Messaging module will physically permit more than 48 stations
to be installed in the 5-slot carrier. In these configurations, only
station ports and voice messaging ports up to 48 will function.
Station ports and voice messaging ports above 48 will not
function with ETR or T/R telephones because they are outside
the PARTNER ACS dial plan.