Avaya PARTNER-18D User Manual
Page 71
6 Maintaining Your System
Using a PC Card
61
Quick Reference Guide
6
In Release 3.0 or later systems, the LEDs on the processor module (center
slot) will alternate red/green while the upgrade is being performed. When
the upgrade is finished, the LED will appear steady green. Make sure each
module has a green LED in the same horizontal area, and that they all
appear steady green. This indicates that each module is powered up.
• If a single light is out, power down the control unit, reseat the module and
power up the control unit.
• If multiple lights are out, power down the control unit, reseat the leftmost
module that has a light out, and power up the control unit.
• If the lights are still out, call for support as instructed on the inside front
cover of this guide.
7
Follow the procedures below:
a
If you are upgrading from Release 1.0 to Release 2.0, power down and
remove the PC upgrade card.
a
If you are upgrading to Release 3.0 or later, do not remove the PC card.
The card automatically converts to a backup/restore and remote access
card. If you removed other PC cards, PVM or ASA/DXD, for example,
power down the system and reinstall the PC cards after the upgrade is
complete.
8
If you have a 2-slot carrier or a stand-alone configuration, you are finished
with this procedure. If you have a 5-slot carrier, continue with Step 9.
9
Make sure all modules are seated properly. (For Release 3.0 and earlier
systems, the cover will not fit if the modules are not seated properly.) If you
have a system of Release 4.0 or later, you are finished with this procedure.
If you have a system of Release 3.0 or earlier, continue with Step 10.
10
To replace the cover, grasp it by its upper edges and hold it squarely over
the control unit. Place the cover over the modules and make sure it fits
firmly in place.
PARTNER ACS Release 5.0 or later provides a firmware upgrade
capability for the 1600 DLS and 012E modules. If you are
performing a firmware upgrade of either of these modules, see
“Upgrading 1600 DSL and 012E Module Firmware” on page 62
for a
description of how the LEDs appear during the upgrade.