Avaya PARTNER-18D - Manual (Page 70)

6 Maintaining Your System
60 Using a PC Card
Quick Reference Guide
Using a PC Card
Follow these steps to upgrade your system’s software with a PC card:
CAUTION:
Before starting, verify that you have batteries installed in the processor
module by viewing the display of the telephone at extension 10.
1 If you have a 5-slot carrier, move the carrier’s On/Off switch to the “Off”
position (“O”).
2 For all types of installations, disconnect the power cord from the wall outlet.
3 If you do not have a 5-slot carrier or have a system of Release 4.0 or later,
go to Step 4. If you have a 5-slot carrier of Release 3.0 or earlier:
a Loosen the screw on the lower front of the cover.
b Place one hand on the handle on the bottom front of the cover and place
your other hand on the top of the cover, and gently pull the cover up and
away from the carrier. Be careful not to break the tabs that attach the
cover to the carrier.
CAUTION:
Remove all other PC Cards from the processor before initiating an upgrade.
4 To insert the PC Card, hold it with the label facing to the right, and slide it
gently into either PC Card slot on the processor module. When inserted
properly, the PC Card projects about 1-5/8 inch (4 cm) from the module.
5 Power up the system:
a Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush
against the plastic case. Do not install the power cord at an angle to
the case or with a loop in it.
b If you have a 5-slot carrier, move the carrier’s On/Off switch to the “On”
position (“–”).