Allied Telesis AT-S62 - Manual (Page 125)

AT-S62 Web Browser Interface User’s Guide
Section II: Advanced Operations 125
UDP Source Port
Defines a traffic flow by source UDP port. To set this parameter, IP
Protocol must be set to UDP.
UDP Destination Port
Defines a traffic flow by a destination UDP port. To set this
parameter, IP Protocol must be set to UDP.
User Specified Protocol
Defines a traffic flow by a protocol other than one of those listed
in the Protocol or IP Protocol list. To set this parameter, Protocol
must be set to User Specified. Alternatively, you can set this
parameter is IP Protocol is set to User Specified.
10. After you have finished configuring the necessary parameters, click
Apply.
11. To permanently save your changes, select the Save Config menu
selection.