Allied Telesis AT-S62 - Manual (Page 171)

AT-S62 Web Browser Interface User’s Guide
Section II: Advanced Operations 171
Configuring Denial of Service Attack Defense
To configure the ports on the switch for a Denial of Service defense,
perform the following procedure:
1. From the Home Page, select Configuration.
2. From the Configuration menu, select Security.
3. Select the DoS tab.
The DoS tab is shown in Figure 53.
Figure 53 DoS Tab
4. If you are implementing the SMURF or Land defense, you must
provide an IP address and mask for your LAN. To accomplish this, do
the following steps. Otherwise, skip ahead to Step 5.
a. In the DoS LAN Subnet IP field, enter the IP address of one of the
devices connected to the switch, preferably the lowest IP address.