Configuring the snmpv3 view table, Creating a view table entry – Allied Telesis AT-S62 User Manual
Page 195
AT-S62 Web Browser Interface User’s Guide
Section III: SNMPv3 Operations
195
Configuring the SNMPv3 View Table
You can create, delete, and modify an SNMPv3 View Table entry. See the
following procedures:
❑ Creating a View Table Entry on page 195
❑ Deleting a View Table Entry on page 198
❑ Modifying a View Table Entry on page 199
For reference information about the SNMPv3 View Table, see
Configuring the SNMPv3 View Table on page 195.
Creating a View
Table Entry
To create an entry in the SNMPv3 View Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
View Table. Then click Configure at the bottom of the page.
The SNMPv3 View Table Page is shown in Figure 62.
Figure 62 SNMPv3 View Table Page