Allied Telesis AT-S62 - Manual (Page 258)

Chapter 20: STP, RSTP, and MSTP
Section IV: Spanning Tree Protocols 258
Configuring MSTP
This section is divided into the following procedures:
❑ Configuring MSTP and CIST Parameters on page 258
❑ Associating VLANs to MSTIs on page 261
❑ Configuring MSTP Port Parameters on page 264
This procedure assumes that you have already designated MSTP as the
active spanning tree on the switch. For instructions, refer to Enabling or
Disabling Spanning Tree on page 248.
Configuring
MSTP and CIST
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the Spanning Tree tab.
The Spanning Tree Web Page appears as shown in Figure 91 on
page 248.
4. Click Configure.