Allied Telesis AT-S62 - Manual (Page 40)

Chapter 3: Basic Switch Parameters
Section I: Basic Operations 40
Rebooting a Switch
Note
Any parameters changes that have not been saved will be discarded
when a system is reset. To save parameter changes, refer to Saving
Your Parameter Changes on page 23.
To reboot a switch, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the System menu option.
3. Select the General tab.
The General tab is shown in Figure 7 on page 32.
4. Click the Reset button.
A confirmation prompt is displayed.
5. Click OK to reset the switch or Cancel to cancel the procedure.
Note
The switch does not forward packets while it initializes the AT-S62
management software and loads the configuration file.
Resetting the switch ends your web browser management
session. You must restart the session to continue managing the
switch.