Allied Telesis AT-S62 - Manual (Page 198)

Chapter 19: SNMPv3 Protocol
Section III: SNMPv3 Operations 198
Deleting a View
Table Entry
To delete an entry in the SNMPv3 View Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 186.
4. In the SNMPv3 section of the page, click the circle next to Configure
View Table. Then click Configure.
5. The SNMPv3 View Table Page is shown in Figure 62 on page 195.
6. Click the circle next to the View Table entry that you want to delete.
Then click Remove.
A warning message is displayed. Click OK to remove the View
Table entry.
7. To save your changes, select the Save Config menu selection.