Nikon D810 User Manual
Page 464
440
Remote
terminal
accessories
• GPS Adapter Cord MC-35 (0 233): This 35 cm (1 ft 2 in.) cable
connects the camera to older GARMIN eTrex- and
geko-series GPS units that conform to version 2.01 or
3.01 of the National Marine Electronics Association
NMEA0183 data format. Only models that support PC
interface cable connections are supported; the MC-35
can not be used to connect GPS units via USB. The
units connect to the MC-35 using a cable with a D-sub
9-pin connector provided by the manufacturer of the
GPS device; see the MC-35 instruction manual for
details. Before turning the camera on, set the GPS
device to NMEA mode (4800 baud); for more
information, see the documentation provided with the
GPS device.
• Modulite Remote Control Set ML-3: Allows infrared remote
control at ranges of up to 8 m (26 ft 3 in.).
HDMI cables
(
HDMI Cable HC-E1
: An HDMI cable with a type C connector
for connection to the camera and a type A connector for
connection to HDMI devices.
Filters
• Filters intended for special-effects photography may
interfere with autofocus or the electronic rangefinder.
• The D810 can not be used with linear polarizing filters.
Use the C-PL or C-PLII circular polarizing filter instead.
• Use NC filters to protect the lens.
• To prevent ghosting, use of a filter is not recommended
when the subject is framed against a bright light, or
when a bright light source is in the frame.
• Center-weighted metering is recommended with
filters with exposure factors (filter factors) over 1× (Y44,
Y48, Y52, O56, R60, X0, X1, C-PL, ND2S, ND4, ND4S,
ND8, ND8S, ND400, A2, A12, B2, B8, B12). See the filter
manual for details.