Nikon D2H - Manual (Page 213)

201
Menu Guide—Custom Settings
Custom Setting f4: FUNC. Button
This option controls the function performed by
the FUNC. button. Highlight f4 FUNC. Button
in the second level of the CSM menu (
172)
and press the multi selector to the right. Press the
multi selector up or down to highlight an option,
then press to the right to make a selection.
OK FV Lock
FV Lock/Lens data
1 step spd/apeture
Same as AE-L/AF-L
Flash off
Bracketing burst
f4 Assign FUNC. Button
CSM MENU
Option Description
FV Lock/
Lens data
If SB-800 Speedlight is attached and on, fl ash value locks while FUNC.
button is pressed. Otherwise focal length of non-CPU lens can be set
with FUNC. button and main command dial, maximum aperture with
FUNC. button and sub-command dial (
124).
FV Lock
(default) If SB-800 Speedlight is attached, fl ash value locks while FUNC. button
is pressed.
1 step
spd/
aperture
If FUNC. button is pressed when rotating command dials, changes to
shutter speed (exposure modes S and M) and aperture (exposure modes
A and M) are made in increments of 1 EV.
Flash off
To temporarily disable fl ash, press shutter-release button while FUNC
button is pressed.
Same as
AE-L/AF-L FUNC. button performs same functions as AE-L/AF-L button.
Bracket-
ing burst
While FUNC. button is pressed, all shots in exposure or fl ash bracketing
program will be taken each time shutter-release button is pressed. In
continuous high-speed and continuous low-speed modes, camera will
repeat bracketing burst while shutter-release button is held down. If
white-balance bracketing is selected, camera will take photos at up to
8 fps (single or continuous high-speed mode) or 1–7 fps (continuous low-
speed mode) and perform white balance bracketing on each frame.
Center-
weighted Center-weighted metering activated while FUNC. button is pressed.
Matrix
metering Matrix metering activated while FUNC. button is pressed.
Spot
metering Spot metering activated while FUNC. button is pressed.