Alpine SEC-8058 - Manual (Page 154)

154
Using the CVA-1000
(sold separately)
English
Sensor Adjustment (Im-
pact Sensor)
1 Enter the vehicle.
Turn the ignition switch to the ON
position.
2 Turn on the power of the CVA-1000.
Note: Do not start the engine.
Toggle the Disarm/Valet switch to the ON
position for one second. The Extension LED
will blink for one second.
Press and release the TX/PANIC and EXT1/
VALET buttons simultaneously. The system
will enter RADAR sensitivity adjustment
mode. Proceed to step
4 .
The CVA-1000 will display the radar "Sensor
Adjust" screen.
Again, toggle the Disarm/Valet switch to the
ON position for one second. The security
system will enter impact pre-warn sensitivity
and display the settings for impact sensor
adjustments on the CVA-1000 screen.
Press the TX/PANIC button to increase the
impact sensor's sensitivity. Press the EXT1/
VALET button to decrease the impact
sensor's sensitivity. The impact sensor's
coverage, represented by a number from 1 to
15 on the CVA-1000 display, will change
respectively.
TX/PANIC button: UP
EXT1/VALET button: DOWN
Note: If sensed, the Extension LED will blink
once.
VALET
2
3
TX
PANIC
E
X
T
1
/V
A
L
E
T
and/et/y
(SEA-8481)
3.%
ACC
OFF
ON
RUN
1
4
VALET
5
TX
PANIC
E
X
T
1
/V
A
L
E
T
or/ou/o
(SEA-8481)
Security
MODE
IMPACT (PRE-WARN) : LEVEL 2
IMPACT (TRIGGER) : LEVEL 14
SENSOR
ADJUST