Sony PFM-50C1 - Manual (Page 101)

47
(GB)
Self-diagnosis Function
The unit has a self-diagnosis function.
This function shows the display’s condition based on
the pattern shown by the flashing of the STANDBY
indicator. The flashing pattern informs you of the
display’s current condition.
If the STANDBY indicator flashes, check the number
of flashes and contact your authorized Sony dealer.
1
Check the flashing pattern of the STANDBY
indicator.
The indicator flashes (with an image showing on
the display) or flashes at intervals of three seconds
(with no image showing on the display).
Count the number of flashes if the indicator
flashes at intervals of three seconds. For example,
the indicator flashes twice, followed by a three
second pause, two more flashes and this pattern
repeats. In this case, the count for the number of
flashes is two.
2
Unplug the unit.
Inform your authorized Sony dealer of the number
of flashes.
Power Saving Function
1
In the Timer/Clock menu, press M/m to move the
cursor (yellow) to “Auto Shutoff” and press
ENTER.
The following menu appears on the display panel.
T i m e r / C l o c k
S l e e p : O f f
C l o c k S e t
C l o c k D i s p l a y : O f f
O n / O f f T i m e r : O f f
A u t o S h u t o f f :
, t o s e l e c t , p r e s s
t o r e t u r n
ENTER
O f f
5 m i n
1 0 m i n
2
Press M/m to select the length of time until the
change to power saving mode.
Off: The power saving function does not work.
5min: Changes to the power saving mode after
five minutes if there is no input signal.
10min: Changes to the power saving mode after
10 minutes if there is no input signal.
When the power saving mode is on, the unit
changes to standby mode.
To cancel the power saving function
Press the 1 switch on the 1 (standby) switch /
indicator section or the POWER ON switch on the
Remote Commander.
Controlling Power On/Off Automatically (Timer Function) /Self-diagnosis Function