Sony PFM-50C1 - Manual (Page 79)

25
(GB)
Using On-screen Menus
Remote Mode
Selects the Remote Commander mode.
TV: The Sony display’s or the TV’s commander
PJ: The Sony projector’s commander
Off: Disables the remote control.
Note
When you change the Remote Commander mode, use the
buttons on the display unit. You cannot change the
Remote Commander mode with the Remote Commander.
For details, see “Using Other Remote Commander
Models” on page 49 (GB).
Remote Only
Select On to disable the control buttons on the display
unit. The display can only be controlled with the
Remote Commander.
To cancel the Remote Only mode, set Remote Only to
Off with the Remote Commander.
Note
The setting in this item is still retained when the AC
power cord is disconnected or when you turn the
display on/off with the Remote Commander.
Input Select menu
This menu is used to switch the input signal.
For details on switching the input signal, see “Switching
the Input Signal” on page 26 (GB).
Unit Status menu
This menu is used for displaying the internal status of
the display unit.
, t o s e l e c t i t e m
U n i t S t a t u s
M o d e l N a m e : P F M - 5 0 C 1
S e r i a l N u m b e r : 2 0 0 0 0 0 1
O p e r a t i o n T i m e : 0 0 0 0 1 H
S o f t w a r e V e r s i o n : 1 . 0 0
T e m p e r a t u r e : O K
F a n : O K
S y n c M o d e : H / C o m p
Model Name
Indicates the model name.
Serial Number
Indicates the serial number.
Operation Time
Indicates the total number of hours of operation.
Note
The standby mode is not counted as part of the
Operation Time.
Software Version
Indicates the system software version.
Temperature
Indicates whether the internal temperature of the
display unit is normal.
OK: Normal
NG: Unusual
When the internal temperature is unusual, NG is
displayed and the item flashes in red. The STANDBY
indicator on the 1 (standby) switch / indicator section
also flashes.
Note
When the ventilation holes are blocked or the display
is used in a place with poor ventilation, “NG” may be
displayed, flashing in red. In this case, check that the
ventilation holes are not blocked and install the
display unit in a well ventilated location. If the
message is still shown, contact your authorized Sony
dealer.
When the STANDBY indicator flashes or NG is indicated,
see “Self-diagnosis Function” on page 47 (GB).
Fan
Cooling fans are built into this display unit. This item
indicates whether the cooling fans work properly.
OK: Normal
NG: Unusual
When the cooling fans are not working normally, NG
is displayed and the item flashes in red. The
STANDBY indicator on the 1 (standby) switch /
indicator section also flashes.
Notes
• If “NG” is displayed, flashing in red, contact the
dealer from whom you purchased the unit, or your
nearest Sony Service Center.
When the STANDBY indicator flashes or NG is indicated,
see “Self-diagnosis Function” on page 47 (GB).
• The cooling fans detect the display unit’s internal
temperature and control the fan rotation. If the
ambient temperature is high, the fan speed increases
and the fan noise will be louder.